Browse

Mouseover to zoom or click to enlarge

Gaugemaster GM387 OO/HO Service Vehicle Lighting Kit

Product code: AA5248
£12.95
  • Currently out of stock
For all stock enquiries relating to this product please enter your email address below:

Suitable for OO/HO Scale vehicles

This Vehicle Lighting Kit gives you the opportunity to enhance any diecast vehicle. Contains everything you need to fit one vehicle.

1xFlasher Unit

1xResistor

2x Red LEDs

2xWhite LEDs

2x Orange LEDs

1xBattery Box

1x 3v Battery – CR2032

1.2mm Drill Bit

GAUGEMASTER

GM385/6/7 VEHICLE LIGHTING KIT

Your new vehicle lighting kit gives you the opportunity to enhance any model, so before you

start please check all the contents are correct for your requirements.

Check List:

1 x Flasher Unit 1 x Resistor 1 x 1.2mm Drill Bit

2 x Red Led’s 1 x Battery Box 2 x Blue Led’s (GM386 Only)

2 x White Led’s 1 x 3v Battery – CR2032 2 x Orange Led’s (GM387 Only)

Let’s start with the basics, the battery must be inserted into the battery box with positive of

the battery towards the positive on the box (look for the large + mark on the box). The box

itself has 3 terminals, the outer pair are positive + and the centre one negative – you can use

the two positive terminals as a direct supply for the flasher unit and as connection to solder

the resistor. Now about the Led’s, remember the Black wire is positive and White is negative

and any power going to any Led must be via the resistor on one or other wire. So for a simple

set of front and rear light you only need to attach the resistor to the battery box positive and

the Led White wires to the battery box negative. The remaining Black wires will now go to the

free end of the resistor and any excess trimmed.

A 1.2mm drill has been included to make holes to emit light and make passages to feed

wires, with so many possibilities we can’t possible say where or how to install all the parts but

as modellers we are confident if it can be done someone will do it.

Last but not least we have the amazing flasher unit that is used to create the effects. As you

can see from the diagram there is a positive and negative terminal, these need to attach to

the battery box with some suitable wire. The circuit can only be turned on and off by removing

the battery but a switch can be used if required in the positive supply wire. Terminals 1-5 are

for the Led (white) negative wires, using a single Led on any of these terminals will give a

pulse effect or using a pair of Led’s on terminals 2 and 4 will result in a toggle effect. If you

connect one Led on each of the five terminals a strobe effect can be achieved, extra GM Nano Led’s can be purchased to suit your needs.

Bourton Model Railway - Tue Aug 20 19:26:06 BST 2019 [web4]